Crestron TPS-XDS Guía de instalación descargar pdf (Pagina 9)

Crestron TPS-XBTP Battery Pack for TPS-XTXRF

Charging & Discharging

NOTE: Typically, the battery pack is good for 500 charge/discharge

cycles.

Charging

To charge the TPS-XBTP:

• Use the TPS-XBC Battery Charger; or

• Install the TPS-XBTP in a TPS-XTXRF equipped touchpanel that

is docked to a powered TPS-XDS Docking Station.

NOTE: An external power pack or Cresnet power connected directly to

the TPS-XTXRF equipped touchpanel does NOT charge the TPS-XBTP.

For further information, consult the TPS-XBC Operations Guide (Doc.

6017) and TPS-XDS Operations Guide and (Doc. 5846). The latest

versions of the guides are available from the Downloads | Product

Manuals section of the Crestron website (www.crestron.com).

Discharging

Over time, the battery pack may not accept a full charge. If you think that

the touchpanel’s level indicator is inaccurate, you may need to discharge

the battery. For example, the level indicator may read 80%, even though

the charge LED on the TPS-XDS goes out (indicating a full charge). If

this occurs, you need to fully discharge the battery pack. To discharge,

insert the battery pack in an undocked TPS-XTXRF equipped

touchpanel, and allow the touchpanel to remain ON until it no longer

operates and/or the control system power/battery gauge indicates

minimum. This also establishes the gauge minimum level.

NOTE: After fully discharging the battery, fully charge the battery (see

Charging instructions above).

NOTE: The battery pack discharges at a rate of 25% per month when not

used, which may cause an inaccurate reading on the level indicator.

Operations and Installation Guide - DOC. 5845 Battery Pack for TPS-XTXRF: TPS-XBTP • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Crestron TPS-XDS Guía de instalación Pagina 9