Crestron Lighting Design Guía de instalación descargar pdf (Pagina 53)

230 V Lighting Design Guide

Doc. 4859C | crestron.com

SLAB 4B: Same operation as SLAB 4A, but intended for a heat pump type second stage. Relay output connections

are terminal W1 for slab heat, with heat pump-type connections on terminals Y1/O/G for cooling and heating calls.

Auxiliary heat is on terminal W2.

SLAB 5A: One stage space heat and cool with ﬂoor warming. Combines the operation of a space heating/cooling

thermostat with a ﬂoor-warming thermostat. Maintains the slab at slab setpoint and maintains the space at the

heat, cool, or auto setpoints. Systems effectively operate independently. Heat/Cool/Auto/ sets the slab mode.

Intended for heat-cool style systems, with slab connection on terminal W1, space heat on terminal W2, and space

cool on terminal Y1.

SLAB 5B: Same as SLAB 5A, but for heat pump space systems, with slab heat on terminal W1, and space heat/

cool on terminals Y1/O/G. Auxiliary heat is on terminal W2.

Sensor Products

CHV-RTHS

The CHV-RTHS is a wall-mounted remote temperature and relative

humidity sensor designed for use with select Crestron thermostats. Using

CAT5 or similar low-capacitance wire, the remote sensor may be mounted

up to 500 ft from the thermostat. One-piece mounting and a single

non-polarized twisted-pair connection make the CHV-RTHS simple to

install. The 1 1/2 inch diameter face protrudes just 1/8 inch from the wall

surface and is easily painted or wallpapered to blend into the wall surface.

Up to two CHV-RTHS sensors may be connected to a single CHV-THSTAT,

CHV-TSTAT, or CHV-TSTATEX thermostat.

CHV-RTS

The CHV-RTS is a wall-mounted remote temperature sensor designed

for use with select Crestron thermostats. The 1 1/2 inch diameter face of

the CHV-RTS protrudes just 1/8 inch from the wall surface and is easily

painted or wallpapered to blend into the wall surface.

CHV-RSS

The CHV-RSS is a remote temperature sensor designed for use with select

Crestron thermostats. Ideally suited for concrete slab, under ﬂoor, or any

outdoor installation, the CHV-RSS is an extremely accurate temperature

sensor potted within a rugged waterproof stainless steel sleeve.

C2N-RTHS

The C2N-RTHS is a wall-mounted temperature and relative humidity

sensor that communicates directly with any 2-Series control system via

the Cresnet control network. One-piece mounting makes the C2N-RTHS

simple to install. The 1 1/2 inch diameter face protrudes just 1/8 inch from

the wall surface and is easily painted or wallpapered to blend into the wall

surface.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 81 82

Sin comentarios

Crestron Lighting Design Guía de instalación Pagina 53