Crestron ATC-AMFM2 Guía de instalación descargar pdf (Pagina 10)

Dual AM/FM Radio Tuner Card Crestron ATC-AMFM2

4. As shown in the following photo, position the ATC-AMFM2 card so the

print on the faceplate is right side up and the side rails of the card slide into

the plastic slots mounted on left and right inside walls of the host system.

ATC-AMFM2 Installed in an AMS-AIP

5. Push the ATC-AMFM2 card into the slot until it stops at the rear connector,

and then push again until the ATC-AMFM2 card snaps into place.

6. Secure the card in place by tightening the two slotted screws by hand. The

screwdriver slots are provided for removal only.

7. Connect antenna(s).

8. Apply power.

Regional Configuration

Once the tuner card is installed, users may change tuner configuration for North

American or European signal reception. For details, refer to the latest version of the

host system’s Operations Guide which can be downloaded from the Crestron Web

site (

www.crestron.com/manuals).

Hardware Hookup

Make the necessary connections as called out in the illustration that follows this

paragraph. Apply power after the connections have been made.

Hardware Connections for the ATC-AMFM2

AM ANT:

Connect Supplied

AM Antennas

FM ANT:

Connect Supplied

FM Antennas

6 • Dual AM/FM Radio Tuner Card: ATC-AMFM2 Operations & Installation Guide – DOC. 7216A

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sin comentarios

Crestron ATC-AMFM2 Guía de instalación Pagina 10