Crestron DA-1700CW Guía de instalación descargar pdf (Pagina 17)

Crestron DA-1700CW Docking Assembly for STX-1700CW/CXPW

Example Program

An example program for the DA-1700CW is available from the Example Program

section of the Crestron website (http://www.crestron.com/exampleprograms). Search

for DA-1550CW_DA-1700CW Example Program (ZIP).

Operation

The DA-1700CW docks the touchpanel, provides power and communication, and

recharges the ST-BTPN. Operation consists of docking the touchpanel (performed by

hand) into the DA-1700CW or undocking electrically via the control system and then

removing by hand.

Docking the Touchpanel

To dock the touchpanel, refer to the procedure below.

NOTE: Do not dock the touchpanel into the DA-1700CW without the ST-BTPN

being installed in the touchpanel. Operating power for the DA-1700CW is supplied

through the electrical contacts of the ST-BTPN. If the ST-BTPN is not installed, the

DA-1700CW will not electrically unlatch the touchpanel.

1. Refer to the diagram below. Insert the bottom edge of touchpanel docking

plate (located on the rear of the touchpanel) into DA-1700CW directly

behind the front panel.

Insert Touchpanel

2. Refer to the diagram on next page. Make sure that the touchpanel is

squarely seated in DA-1700CW and press upper edge of touchpanel

inward to dock the touchpanel. The touchpanel will snap into position.

Operations and Installation Guide - DOC. 6104A Docking Assembly for STX-1700CW/CXPW: DA-1700CW • 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Crestron DA-1700CW Guía de instalación Pagina 17