Crestron PMK-6X-DSW Guía de instalación descargar pdf (Pagina 13)

Crestron TPS-6X-DSW Wall Mount Docking Station for TPS-6X

1. The TPS-6X-DSW is shipped with the docking mechanism locked in its

“back” position. In order to make cable connections, the mechanism must

first be unlocked so it slides to the “forward” position. To do this, slide the

release latch on the right side of the TPS-6X-DSW upward to release the

mechanism. The mechanism will slide forward. To locate the release latch,

refer to illustration on page 5, showing the front view of the TPS-6X-DSW.

Callout #2 points to the release latch.

2. Remove the four screws holding the cover plate in place, to gain access to

the connectors on the TPS-6X-DSW.

TPS-6X-DSW Installation – Cover Plate Removal

Before mounting the unit into the wall,

remove the cover plate to access the

connectors. Once all cables are

connected, replace the cover plate.

3. Hold the TPS-6X-DSW near the back box and connect the NET, VID IN

and LAN cables from the back box to the ports on the back of the unit.

(Refer to “Hardware Hookup” on page 12 for details.)

4. Replace the cover plate, using the four screws from step 2.

5. Place the TPS-6X-DSW into the back box (or against the PMK-6X-DSW if

using this instead of the back box) and using the four supplied

#06-32 x 1 1/2” screws (2007254), two at the top and two at the bottom, to

attach the TPS-6X-DSW to the back box, as shown in the illustration on the

following page.

Operations & Installation Guide – DOC. 6708B Wall Mount Docking Station for TPS-6X: TPS-6X-DSW • 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

Crestron PMK-6X-DSW Guía de instalación Pagina 13