Crestron ST-DSN Especificaciones descargar pdf (Pagina 12)

1-Way Wireless RF Touchpanel Crestron ST-1700C

Select Interface

SELECT INTERFACE

CRESNET INTERFACE MENU

SELECT RF ID

The touchpanel communicates with a control system to activate commands or to

display feedback from components within the system. The communication interface

must be correctly specified or communication will not occur. To set communication

parameters, first select the Interface button on the SETUP MENU to display the

SELECT INTERFACE screen, shown to the left. Then, select either the CRESNET

or the RF button to display the CRESNET INTERFACE MENU or the SELECT RF

ID screen, respectively. Use these screens to set the Cresnet network identity (Net

ID) and the RF ID numbers.

Cresnet Interface Menu

CRESNET ID is a two-digit hexadecimal number that can range from 03 to FE, used

only during screen uploads to the touchpanel or upgrading the touchpanel firmware.

Net ID for the ST-1700C is factory set to 03.

The UP and DOWN buttons increase and decrease the CRESNET ID by one digit

(i.e., 03, 04, 05, . . . FE).

Select the Return button to return to the SELECT INTERFACE screen.

RF Setup

RF ID, the radio frequency identity number, is necessary to secure RF

communications such that controls can be activated from the touchpanel. The RF ID

consists of a two-digit hexadecimal number. The touchpanel can be set to one of

fifteen numbers; “10” is shown as an example in the illustration and happens to be

the default. The RF ID setting should match the value assigned to the ST-1700C

touchpanel definition is the SIMPL Windows program. Refer to page 12 for

information about SIMPL programming/setup for this touchpanel.

The UP and DOWN buttons increase and decrease the RF ID most significant digit

by one, respectively (i.e., 10, 20, 30, …, F0).

After the Cresnet ID and RF ID settings have been verified, touch the Return

utton

to save the settings and display the SELECT INTERFACE screen.

KEY CLICK SETUP SCREEN

Key Click Setup

From the SETUP MENU, press the Key Click Enabled button to open the KEY

CLICK SETUP screen. (If the function is currently disabled, the button legend is

“Key Click Disabled.”)To enable an audible tone (beep) when the touchpanel

buttons are pressed, select among the Short, Med, or Long KEY CLICK

ENABLE/LEN buttons to set the duration of the tone. The touchpanel responds with

a corresponding signal. To disable the feature, select Click Off.

Use the KEY CLICK VOLUME UP and DOWN buttons to increase and decrease

the volume of the signal. The display to the right of the buttons shows the relative

volume from 0% to 100%, both as a numeric value and, for a quick visual reference,

as an analog bar.

Select the Return button to return to the SETUP MENU.

8 • 1-Way Wireless RF Touchpanel: ST-1700C Operations Guide – DOC. 6225A

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comentarios a estos manuales

Sin comentarios

Crestron ST-DSN Especificaciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Estaciones de muelle de dispositivos móviles Crestron ST-DSN