Crestron TPMC-10-DSW Guía de instalación descargar pdf (Pagina 9)

Crestron TPMC-3X-DSW Wall Mount Docking Station for TPMC-3X

Setup

Installation

To prevent overheating, do not operate this product in an area that

exceeds the environmental temperature range listed in the table of

specifications.

The following tools and accessories are required for installation of a

TPMC-3X-DSW:

• Standard 1-gang electrical box (not supplied)

• Flat head screwdriver (not supplied)

• Two #06-32 x 1” screws (included)

After Cresnet

power (or other Crestron 24 Volt power source) wiring

has been installed and verified, use the following procedure to install the

TPMC-3X-DSW.

1. Turn system power OFF.

2. Connect the power supply cable to the 24 and G pins on the

TPMC-3X-DSW’s PWR connector.

3. Attach the TPMC-3X-DSW to the electrical box using the two

supplied #06-32 x 1” screws (2013235).

CAUTION: Excess wire that is pinched between the TPMC-3X-DSW

and the electrical box could short out. Make sure all excess wire is

completely inside the electrical box and not between the box and the

TPMC-3X-DSW.

4. Attach the wall plate using the screws that came with the wall

plate.

5. Turn system power ON.

Operations & Installation Guide – DOC. 6816A Docking Station: TPMC-3X-DSW • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Crestron TPMC-10-DSW Guía de instalación Pagina 9