Crestron TPMC-3X-DSW Especificaciones descargar pdf (Pagina 18)

Isys™ 2.8” Handheld WiFi Touchpanel Crestron TPMC-3X

NOTE: The TPMC-3X can become unresponsive when battery strength is low.

Battery Calibration

For optimum performance after shipping or any time the unit’s power has been off

for an extended period of time, Crestron recommends the following procedure be

performed:

1. Place the unit on its docking station/charger and connect AC power.

2. Allow the unit to charge completely. (The green LED should be steady on

for 15 minutes.)

3. Remove panel from the docking station/charger.

4. From the main setup screen, touch Diagnostics, then touch Battery Diags

to go to the Battery Diagnostics screen. Touch Recondition Battery, then

touch YES, Recondition Battery to confirm. (Refer to “Configuring the

Touchpanel” which starts on page 15.)

5. Wait for the unit to shut off. This takes approximately five hours. Leave the

unit off the dock the entire time. During this operation, the Battery

Reconditioning screen shown on page 25 will be displayed until the unit

shuts off.

6. Place the unit back on the docking station and allow it to charge completely.

7. Unit is now ready for normal operation.

Optimizing Battery Life

In order to maximize battery life, use the following settings:

1. From the main setup screen, touch Standby Setup to enter the Standby

Timeouts screen (refer to “Standby Setup” on page 22). Use an Undocked

Standby setting of 30 and an Undocked Power Off setting of 45.

2. From the main setup screen, touch LCD Settings to enter the Display

Settings screen (refer to “LCD Settings” on page 27). Use an Undocked

Brightness setting of 50.

14 • Isys™ 2.8” Handheld WiFi Touchpanel: TPMC-3X Operations Guide – DOC. 6789F

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Sin comentarios

Crestron TPMC-3X-DSW Especificaciones Pagina 18