Crestron TPS-6XNL-DS-C Manual de usuario descargar pdf (Pagina 8)

Battery Pack for TPS-6X Crestron TPS-6X-BTP

Setup

Removal

NOTE: The TPS-6X Wireless Touchpanel contains ESD (electrostatic

discharge) sensitive devices. To avoid damaging the unit, perform the

following procedure while wearing a grounding strap that is properly

grounded or on a grounded workstation.

NOTE: To prevent damage to the multi-pin connector and wiring, use

care when handling the TPS-6X-BTP.

Perform the following procedure to remove the existing TPS-6X-BTP

from a TPS-6X touchpanel. A #1 Phillips screwdriver and a small slot

head screwdriver are required.

1. Remove power from the touchpanel, use the included T-pin to

slide the battery switch on the rear to the OFF (down) position and

place the touchpanel face down on a clean, padded work surface.

(Refer to illustration below.)

Bottom View Showing Battery Switch and Screw Locations

Screws Screws

4 • Battery Pack for TPS-6X: TPS-6X-BTP Installation Guide – DOC. 6740C

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

Crestron TPS-6XNL-DS-C Manual de usuario Pagina 8