Crestron CNX-TS Guía de instalación descargar pdf (Pagina 11)

Crestron CNX-TS Single Gang Temperature Sensor

7. In the "Command Complete" window, click OK.

8. In the Current Network Devices text window, verify the new

NET ID code.

9. In the "Set Network ID" window, click Close.

NOTE: The new NET ID code may also be verified by selecting

Diagnostic | Report Network Devices in the Viewport (alternately,

select F4).

10. Repeat this procedure for each sensor to be added to the

system.

Installation

Tools/hardware required

Temperature sensor and faceplate (supplied)

Cresnet network cable

Phillips screwdriver

Two 3/16 in. flathead phillips screws (supplied)

Insulation (not supplied)

NOTE: The insulation will protect the sensor from any in-the-wall

conditions (such as drafts, etc.). Use type in compliance with local codes.

After the Cresnet network wiring has been installed and verified, use the

following procedure to install the sensor (refer to illustration on page 4)

in a single gang electrical box.

1. Turn Cresnet system power OFF.

2. Connect the Cresnet cable with supplied mate to the sensor’s

Cresnet port and the other end to the control system.

3. Insert insulation in electrical box (make sure it fills void of

box not occupied by sensor).

CAUTION: Excess wire that is pinched between the sensor and

electrical box could short out. Make sure that all excess wire is

completely inside the electrical box and not between the box and the

sensor. The CNX-TS contains an electrostatic sensitive device (ESD).

Observe precautions for handling ESDs to avoid damaging unit.

Operations & Installation Guide - DOC. 8191 Single Gang Temperature Sensor: CNX-TS • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sin comentarios

Crestron CNX-TS Guía de instalación Pagina 11