Crestron Green Light DIN-HUB Guía de instalación descargar pdf (Pagina 16)

DIN Rail 50 Watt Cresnet

Power Supply Crestron DIN-PWS50

Fuse

Replacement

If the DIN-PWS50 does not power up when it is plugged into an AC

outlet, the fuse may need to be replaced. The fuse holder is located on the

front panel, under the cover in the lower left corner. To replace the fuse:

1. Disconnect power to the DIN-PWS50.

2. Remove the cover from the lower left corner on the front of the

DIN-PWS50.

3. Remove the defective fuse from the fuse holder and replace with a

new one.

CAUTION: Use only time lag type fuses, 3.15 Amps / 250 Volts.

Failure to do so may cause damage to the DIN-PWS50.

4. Replace the fuse cover.

5. Connect power to the DIN-PWS50.

12 • DIN Rail Power Supply: DIN-PWS50 Operations & Installation Guide – DOC. 6667A

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Crestron Green Light DIN-HUB Guía de instalación Pagina 16