
GLPP
Crestron Electronics, Inc. 15 Volvo Drive
|
Rockleigh, NJ 07647
Tel: 800.237.2041 / 201.767.3400
|
Fax: 201.7671903
All Crestron products are proudly manufactured in the United States.
SPECIFICATIONS
Load Ratings
Dim/Switched Channels: 1, 2 or 3 switched or dimmed (0-10V) loads
(depending on model)
Per Unit: 16 Amps @ 100-277VAC, 50/60Hz (20 Amps, de-rated to 80%)
Dim Load Types (for dimming models): 0-10V fluorescent ballast (4-
wire); 0-10V LED Drivers; 60mA max current sink
Switched Load Types: Fluorescent Ballast, Incandescent, Magnetic Low-
voltage, Electronic Low-voltage, Neon Cold/Cathode, HID
Relay Lifetime: 1,000,000 cycles
Power Requirements
Power Consumption: Wired Models: 1.5 Watts @ 120-277V, with no sen-
sors or keypad attached; Wireless Models: 2 Watts @ 120-277V, with no
sensors or keypad attached
Main Power: 100-277 Volts AC, 50/60Hz
Available Sensor Power: 2.5W @ 24 Volts DC (sufficient for powering
both the occupancy sensor and photocell)
Controls & Indicators
POWER: (1) Green LED; indicates line voltage supplied to unit
SETUP: (1) Red LED; indicates unit is in setup mode
SETUP: (1) Recessed push button; toggles setup mode
IR RECEIVER: (1) IR window for use with commissioning remote control
Connections (Class 1)
Line In (100-277 VAC): (1) 14 AWG Class 1 flying lead, black
Neutral: (1) 14 AWG Class 1 flying lead, white
Switched Hot: (1, 2 or 3) 14 AWG Class 1 flying lead(s), red, labeled with
channel number
Ground: (1) 14 AWG Class 1 flying lead, green w/yellow stripe
Connections (Class 1) – Dimming Models Only
0-10V dim(+): (1, 2 or 3) 18 AWG Class 1 flying lead(s), violet, labeled with
channel number
0-10V dim(-): (1) 18 AWG Class 1 flying lead, gray
Connections (Class 2)
Common: (1) 18 AWG Class 2 flying lead, black; common for sensors, IR
and Cresnet
Sensor Power (24VDC): (1) 18 AWG Class 2 flying lead, red
Occupancy Sensor Signal: (1) 18AWG Class 2 flying lead, orange
Photocell Signal: (1) 18 AWG Class 2 flying lead, yellow
IR: (1) 18 AWG Class 2 flying lead, brown, for use with (optional) external
IR receiver
[4]
Keypads: (2) 18 AWG Class 2 flying leads, white w/black stripe; supports
up to two (2) GLPPA-KP Power Pack Keypads
Connections (Class 2) – Cresnet Models Only
Cresnet Data Z: (1) 18 AWG Class 2 flying lead, blue
Cresnet Data Y: (1) 18 AWG Class 2 flying lead, white
Connections (Class 2) – infiNET EX Models Only
Antenna: (1) connection for supplied antenna
Enclosure
20-gauge galvanized steel enclosure; designed for mounting to two (2)
adjacent standard 4” square electrical junction boxes
[5]
; 3-channel versions
require a box depth of 2.125 in (5.4 cm)
Environmental
Temperature: 32° to 104°F (0° to 40°C)
Humidity: 10% to 90% RH (non-condensing)
Dimensions
Height: 4.25 in (108 mm)
Width: 8.63 in (219 mm); 9.88 in (251 mm) with antenna at 90° angle
(wireless models only)
Depth: 2 in (51 mm)
Weight
2 lb (907 g)
Electrical Regulatory Certifications (Pending)
Certified to UL916 (Energy Management Equipment)
Relays tested and certified for Electronic Ballasts according to UL508,
Section 41 (Endurance Test) and Section 61C (Electronic Ballasts),
IEC60669-2-1, Section 19.102 (Contact mechanisms incorporated in
electronic switches, intended for fluorescent lamp circuits or other
capacitive loads)
Notes:
1. Model GLPPA-REMOTE-PROG.
2. Crestron photocell models include GLS-LOL, GLS-LCL and GLS-LEXT. Crestron occupancy
sensor models include GLS-ODT and GLS-OIR.
3. Models with suffix “-PM”.
4. IR receiver model GLPPA-IRGW-F.
5. Some models may need a box extension to meet code requirements.
6. Two dedicated wires are required from the keypad location to the GLPP.
This product may be purchased from an authorized Crestron dealer. To find a dealer, please
contact the Crestron sales representative for your area. A list of sales representatives is available
online at www.crestron.com/salesreps or by calling 800-237-2041.
Specifications subject to change without notice. Crestron is not responsible for errors in
typography or photography.
Crestron, the Crestron logo, Crestron Green Light, Cresnet, and infiNET EX are trademarks or reg-
istered trademarks of Crestron Electronics, Inc. Other trademarks and trade names may be used
in this document to refer to either the entities claiming the marks and names or their products.
Crestron disclaims proprietary interest in the marks and names of others.
©2011 Crestron Electronics, Inc.
Comentarios a estos manuales