Crestron MC2W Especificaciones descargar pdf (Pagina 15)

Crestron MC2W 2-Series Integrated Wireless Control System

Hardware Connections for the MC2W

ANTENNA:

FOR RF

SIGNALS FROM

TRANSMITTER

DEVICE

COM:

TO ANY RS-

232, -422, OR -

485 DEVICE

COMPUTER:

TO PC

SERIAL

PORT

POWER:

TO POWER

PACK

(24VDC, 1A

OUTPUT)

IR:

TO IRP2

SERIAL

DEVICES

RECEIVER:

FROM

CNXRMIRD

FOR RC5

CODE

I/O VERSIPORTS:

TO CONTROLLABLE

DEVICES FROM DEVICE

OUTPUTS

-CONTACT CLOSURES

-SOLID STATE CLOSURES

RELAYS:

CONTROLLABLE

DEVICES

CRESNET:

TO ANY

CRESNET

NETWORK

DEVICE

USA740.76

N.IGH,CKLR.O E J

NINICSTROLECONTSRCRE E

ANTENNA

IR SERIAL OUT

IR IN

I/O

RELAY OUT

COM A COM B

COMPUTER

NET

24 VDC

1.0 A

ABC

34G 1 2

24 Y

NOTE: The maximum continuous current from equipment under any external load

conditions shall not exceed a current limit that is suitable for the minimum wire

gauge used in interconnecting cables. The ratings on the connecting unit's supply

input should be considered to prevent overloading the wiring.

Power Supply

The unit can be powered through the NET connector, the included external power

pack (PW-2410RU) or the optional power pack PW-2420RU. With the PW-2410RU,

the MC2W can provide power to peripheral Cresnet devices (via the NET connector)

up to a total of 13 watts. The PW-2420RU allows the MC2W to provide up to 38

watts to peripheral Cresnet devices (via the NET connector).

If additional power is needed, Crestron recommends the Crestron CNPWS-75 (75

watts) External Power Supply or equivalent.

CAUTION: When using the included power pack PW-2410RU, the MC2W’s NET

connector can supply 13 watts (maximum) to Cresnet devices. Do not connect

devices that will exceed this rating as damage may occur to the power pack. To

power additional devices from the MC2W’s NET connector, use the optional power

pack PW-2420RU that can supply up to 38 Watts from the NET connector to

Cresnet devices.

NOTE: In larger system configurations that require more than the 24 VDC supplied

by Cresnet, disconnect the +24 VDC wire from the MC2W Cresnet connector and

provide the +24 VDC power to the peripheral devices by an alternate source.

Operations Guide – DOC. 6143A 2-Series Integrated Wireless Control System: MC2W • 11

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comentarios a estos manuales

Sin comentarios

Crestron MC2W Especificaciones Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Crestron MC2W