Crestron ML-600 Especificaciones descargar pdf (Pagina 12)

Mini LCD RF Wireless Handheld Remote Crestron ML-600

• Mini LCD RF Wireless Handheld Remote Operations Guide – DOC. 6446

Using the Backlight

If it is difficult to see the display or buttons when viewing the remote, the ML-600

backlight can be used to light up the display and buttons.

Turn on the backlight by pressing the LIGHT button on the right side of the remote

control. The backlighting will stay on, and then automatically turn off after

approximately 15 seconds. If you wish to turn off the backlighting without waiting,

press the LIGHT button again.

NOTE : Battery life is reduced with frequent use of the backlight feature.

Installing/Changing the Batteries

If the batteries are running low, the bottom of the LCD display will flash “LOW

BATTERY” whenever the ON button is pressed. Low batteries may shorten the

operating range of the ML-600. To change the batteries, perform the following:

1. While viewing the back of the ML-600, press the latch on the battery

cover (shown in the following illustration) and remove it.

2. Remove old batteries (if installed) and insert new batteries with the

indicated polarity inside the battery compartment. The remote will run a

diagnostic test.

NOTE : Replace all of the batteries at the same time. Do not mix old and new

batteries.

NOTE : The ML-600 will retain its program even when the batteries are removed

for an extended period.

3. Replace the battery cover.

Miscellaneous

Battery Cover Removal

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Crestron ML-600 Especificaciones Pagina 12