Crestron ST-LT Especificaciones descargar pdf (Pagina 16)

CRESTRON

The macro in this sample

shall address MAIN-UNIT-2

and select ZONE-1-UP.

8. A macro is created by adding the appropriate commands and delays as

required. Click the Insert Command button to open the “Device

Functions” dialog box.

8. Highlight the ST-LT in the Device area to display the associated

functions in the right-hand column.

9. Select MAIN-UNIT-2 as the desired function. The dialog box should

appear as shown below; click OK.

Device Functions Dialog Box

11. The software returns to the “Macro Edit” dialog box. Notice that the

first step of the macro addresses MAIN-UNIT-2. Click on Insert

Command, ZONE-1-UP from the Function area, and OK. Once the

macro is complete, select OK to close the “Macro Edit” dialog box.

12. Next, the function must be assigned to a specific button on the lighting

page. With the lighting page open, right-mouse click on the ZONE 1

UP button and select Function from the pop-up.

13. The software displays the “Function” dialog box for that given button.

Click on the [Macro:] field and select ZONE1-UP. The dialog box

should appear as shown below; click OK.

Function Dialog Box

14. Additional macros should be created and assigned for each button on

the lighting page that provides a function. Therefore, repeat steps 6

through 13 for the appropriate buttons.

12 • Lutron Interface Operations Guide - Doc. 5694

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Sin comentarios

Crestron ST-LT Especificaciones Pagina 16