Crestron TPS-4500IMW Especificaciones descargar pdf (Pagina 11)

Crestron TPS-4500IMPC Interface Module

Wire Gauge Values

RESISTANCE (R) WIRE GAUGE

Doubled CAT5

8.7

Tripled CAT5

NOTE: When daisy-chaining Cresnet units, strip the ends of the wires

carefully to avoid nicking the conductors. Twist together the ends of the

wires that share a pin on the network connector, and tin the twisted

connection. Apply solder only to the ends of the twisted wires. Avoid

tinning too far up the wires or the end becomes brittle. Insert the tinned

connection into the Cresnet connector and tighten the retaining screw.

Repeat the procedure for the other three conductors.

Hardware Hookup

The TPS-4500IMPC serves as an interface between the touchpanel and

the Cresnet system. Refer to the illustration after this paragraph for

proper connections; apply power last. When making network connections

to a control system or Cresnet peripherals, refer to “Network Wiring” on

page 5. It is not necessary to make connections to a video source unless a

TPS-4500V touchpanel is used or a TPS-VID-1/2 has been installed into

a TPS-4500 touchpanel and a video window object resides on a page

within the uploaded Crestron VisionTools

Pro-e (VT Pro-e) project.

NOTE: When connecting the net/video cable from the interface module

to the touchpanel, exceeding a cable length of 30 feet will significantly

degrade the video signal. To maintain high-quality video, DO NOT

daisy-chain cables or Crestron TPSBLOCK-10 cables longer than 30

feet. Contact Crestron for the maximum available cable length.

Operations Guide - DOC. 6163 Interface Module: TPS-4500IMPC • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Crestron TPS-4500IMW Especificaciones Pagina 11