Crestron C2-AUDIO-6PAK Especificaciones descargar pdf (Pagina 18)

Six-Zone Audio Package Crestron C2-AUDIO-6PAK

Properties

The Properties tab of the “Device # Properties” window, shown after this paragraph,

lists a set of values for specified functions. Crestron recommends that the default

values are used, but the programmer is free to alter them. Click the OK button to

apply and save any changes made and close the window. The Cancel button closes

the window without saving any changes that have been made.

NOTE: This tab is not available for all devices.

“Device # Properties” Window – Properties Tab

Step 3: Add Rooms

The C2-AUDIO-6PAK is designed

to permit control of up to eight

devices from up to six rooms. If the

intent is to control more than eight

devices or control seven or more

devices from a single room, the

designer should consider using

Crestron AppBuilder to supplement

the Audio Six-Pack Wizard or use

Crestron AppBuilder solely.

The top six buttons on the function keypad are pre-configured for source selection,

where by default the first button (on the top left of the panel) selects Device 1, the

second button (top right) selects Device 2, the third, Device 3 and so forth. In

applications with less than six devices, the extra source selection buttons will have

no function assignment. In those applications with seven or eight devices, the extra

devices will have no source selection buttons in certain rooms of the system. Use

this step to determine which of the available sources can be selected from a given

room.

The C2-AUDIO-6PAK is designed to provide control from up to six locations. The

Interfaces screen of the Wizard allows the user to assign source control from each of

the six rooms. From the pull-down above the user interface on the screen, as shown

after this paragraph, choose a room. The top six buttons of the keypad need to be

assigned to override the default settings. Move the cursor over one of the buttons and

notice that the perimeter of the button changes to a blue color. Selection of a button

changes the perimeter color to red and enables the Selected Source Button area of the

screen. Select an available source from the Source: field and assign a label for the

button on the keypad. Select another room and repeat the process.

NOTE: The keypad has standard source selector switch caps installed and a kit of

custom switch caps is supplied with the C2-AUDIO-6PAK. Instructions for

installing the custom switch caps or re-arranging the standard switch caps is

14 • Six-Zone Audio Package: C2-AUDIO-6PAK Reference Guide – DOC. 8188B

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Sin comentarios

Crestron C2-AUDIO-6PAK Especificaciones Pagina 18