
CLSI-C6MCLSI-C6MCLSI-C6MCLSI-C6M
> Built-in motion detector
> Supports multipoint control using up to 16 keypads
> Optional IR remote
> Master air-gap relay
> Integrates with 2-Series Control Systems via Cresnet
> Energy saving ASHRAE 90.1/LEEDS compliant
> Available in almond, black, or white
SPECIFICATIONSSPECIFICATIONSSPECIFICATIONSSPECIFICATIONS
Load RatingsLoad RatingsLoad RatingsLoad Ratings
Dimmer Channels: 6
Maximum Per Channel: Maximum Per Channel: Maximum Per Channel: Maximum Per Channel: 800 Watts/VA (3.5 Amps @ 230 Volts AC)
Minimum Per Channel : Minimum Per Channel : Minimum Per Channel : Minimum Per Channel : 25 Watts/VA (0.108 Amps @ 230 Volts AC)
Module Total: Module Total: Module Total: Module Total: 2200 Watts/VA (10 Amps @ 220 Volts AC);
2300 Watts/VA (10 Amps @ 230 Volts AC);
2400 Watts/VA (10 Amps @ 240 Volts AC)
Load Types: Load Types: Load Types: Load Types: LED*, Incandescent, Magnetic Low-voltage, Neon/Cold Cathode,
2-Wire Dimmable Fluorescent, & Non-Dim Lighting (also: Electronic Low-
voltage, 3 and 4-Wire Fluorescent, High-Inrush Switching, & 277V via CLS-
EXP Series expansion modules)
Power RequirementsPower RequirementsPower RequirementsPower Requirements
220 to 240 Volts AC, 50/60Hz line power
ConnectionsConnectionsConnectionsConnections
LOCAL DEVICES: LOCAL DEVICES: LOCAL DEVICES: LOCAL DEVICES: (1) 4-pin 5mm detachable terminal block;
Cresnet Master port for local devices including:
• C2N-DB and CNX-B Series keypads, 16 maximum;
• C2N-SSC-2 and C2N-SDC-DC shade controllers; 16 maximum;
• Additional CLSI-C6M or CLSI-C6 units, 8 maximum;
Additional CNPWSI-75 or other Cresnet power supply required beyond 4
devices; C2N-SDC-DC always requires an additional power supply
CONTROL SYSTEM: CONTROL SYSTEM: CONTROL SYSTEM: CONTROL SYSTEM: (1) 4-pin 5mm detachable terminal block;
Cresnet Slave port for connection to a 2-Series control system
HOT: HOT: HOT: HOT: (1) Captive screw terminal†, line power input
LOAD1 - LOAD6: LOAD1 - LOAD6: LOAD1 - LOAD6: LOAD1 - LOAD6: (6) Captive screw terminals†, dimmer channel outputs 1 - 6
NEUTRAL: NEUTRAL: NEUTRAL: NEUTRAL: (1) Captive screw terminal†
GROUND: GROUND: GROUND: GROUND: (1) Captive screw terminal†
PC (front): PC (front): PC (front): PC (front): (1) 3.5mm TRS mini-phone jack, RS-232 Programming port
ControlsControlsControlsControls
Buttons 1 - 6: Buttons 1 - 6: Buttons 1 - 6: Buttons 1 - 6: (6) 3-position rocker pushbuttons; configurable to recall (or
toggle recall/off) individual scenes, control shades, or for master lighting or
shade control; “scene mastering” option enables manual dimming utilizing
rocker button action; also used to adjust lighting levels when in “Lighting”
mode and shade positions when in “Shades” mode; additional functionality
configurable via software
Up/Down Button: Up/Down Button: Up/Down Button: Up/Down Button: (1) 3-position rocker pushbutton; configurable for master
lighting or shade control, or as a “shift” for Buttons 1-6; additional
functionality configurable via software
ON: ON: ON: ON: (1) pushbutton, recalls “On” scene
OFF: OFF: OFF: OFF: (1) pushbutton, turns all lights off
LIGHTS, SHADES: LIGHTS, SHADES: LIGHTS, SHADES: LIGHTS, SHADES: (2) Pushbuttons, select “Lights” or “Shades” modes
SAVE, CANCEL, UP, DOWN: SAVE, CANCEL, UP, DOWN: SAVE, CANCEL, UP, DOWN: SAVE, CANCEL, UP, DOWN: (4) Pushbuttons, navigate and execute setup
functions
Reset: Reset: Reset: Reset: Recessed miniature pushbutton for hardware reset
Dimming Ramp Rate: Dimming Ramp Rate: Dimming Ramp Rate: Dimming Ramp Rate: 5 seconds (default), software adjustable 1 to 10
seconds
Scene Fade Time: Scene Fade Time: Scene Fade Time: Scene Fade Time: 2 seconds (default), software adjustable 0 seconds to 99
minutes
LED IndicatorsLED IndicatorsLED IndicatorsLED Indicators
Scenes: Scenes: Scenes: Scenes: (6-white) Correspond with each “Scene” Button
High/Low: High/Low: High/Low: High/Low: (2-white) Indicate “Shift” status
ON: ON: ON: ON: (1-white) Indicates “On” Scene is selected
LIGHTS, SHADES: LIGHTS, SHADES: LIGHTS, SHADES: LIGHTS, SHADES: (2-green) Indicates “Lights” or “Shades” mode is active
SAVE, CANCEL: SAVE, CANCEL: SAVE, CANCEL: SAVE, CANCEL: (2-green) Correspond with “Save” and “Cancel” Buttons
MIN, SEC: MIN, SEC: MIN, SEC: MIN, SEC: (2-green) Indicates display of “Minutes” or “Seconds”
1 - 6: 1 - 6: 1 - 6: 1 - 6: (6-green) 7-Segment bargraphs, indicate lighting levels and shade
positions
Numeric Display: Numeric Display: Numeric Display: Numeric Display: (2-green) 8-Segment digits, indicates modes and setup
values
IR ReceiverIR ReceiverIR ReceiverIR Receiver
Reception Frequency: Reception Frequency: Reception Frequency: Reception Frequency: 36 kHz
Requires CLS-IRHT8 IR remote, sold separately
Motion DetectorMotion DetectorMotion DetectorMotion Detector
Type: Type: Type: Type: Infrared
Range: Range: Range: Range: 20 to 30 feet at 4 foot elevation
EnvironmentalEnvironmentalEnvironmentalEnvironmental
Temperature: Temperature: Temperature: Temperature: 32° to 104°F (0° to 40°C)
Humidity: Humidity: Humidity: Humidity: 10% to 90% RH (non-condensing)
EnclosureEnclosureEnclosureEnclosure
Mounts in a 4-gang electrical box, 3-1/2" deep minimum
DimensionsDimensionsDimensionsDimensions
Height: Height: Height: Height: 4.48 in (11.38 cm)
Width: Width: Width: Width: 8.89 in (22.58 cm)
Depth: Depth: Depth: Depth: 2.60 in (6.61 cm)
WeightWeightWeightWeight
1.43 lb (0.65 kg)
*
For a list of compatible ballasts, visit www.crestron.com/
lightingcompatibility
(PDF)
†
Captive screw terminals accept up to two 22 to 12 AWG (0.34 to 4.0 mm²)
wires per terminal.
Available ModelsAvailable ModelsAvailable ModelsAvailable Models
CLSI-C6MA:CLSI-C6MA:CLSI-C6MA:CLSI-C6MA: iLux Integrated Lighting System with motion detector -
International Version, 230V, almond
CLSI-C6MB:CLSI-C6MB:CLSI-C6MB:CLSI-C6MB: iLux Integrated Lighting System with motion detector -
International Version, 230V, black
CLSI-C6MW:CLSI-C6MW:CLSI-C6MW:CLSI-C6MW: iLux Integrated Lighting System with motion detector -
International Version, 230V, white
Available AccessoriesAvailable AccessoriesAvailable AccessoriesAvailable Accessories
CLS-EXP-DIM:CLS-EXP-DIM:CLS-EXP-DIM:CLS-EXP-DIM: iLux™ Dimmer Expansion Module
CLS-EXP-DIMFDB:CLS-EXP-DIMFDB:CLS-EXP-DIMFDB:CLS-EXP-DIMFDB: iLux™ 3-Wire Fluorescent Dimmer Expansion Module
CLS-EXP-DIMFLV:CLS-EXP-DIMFLV:CLS-EXP-DIMFLV:CLS-EXP-DIMFLV: iLux™ 0-10V Fluorescent Dimmer Expansion Module
CLS-EXP-DIMU:CLS-EXP-DIMU:CLS-EXP-DIMU:CLS-EXP-DIMU: iLux™ Universal Dimmer Expansion Module
C2N-DB6-W-S:C2N-DB6-W-S:C2N-DB6-W-S:C2N-DB6-W-S: Decorator Keypad, 6-Buttons, White, Gloss
C2N-DB6-A-S:C2N-DB6-A-S:C2N-DB6-A-S:C2N-DB6-A-S: Decorator Keypad, 6-Buttons, Almond, Gloss
C2N-DB8-W-S:C2N-DB8-W-S:C2N-DB8-W-S:C2N-DB8-W-S: Decorator Keypad, 8-Buttons, White, Gloss
C2N-DB8-A-S:C2N-DB8-A-S:C2N-DB8-A-S:C2N-DB8-A-S: Decorator Keypad, 8-Buttons, Almond, Gloss
Crestron Electronics, Inc. 15 Volvo Drive | Rockleigh, NJ 07647
Tel: 800.237.2041 / 201.767.3400 | Fax: 201.767.1905
www.crestron.com
Comentarios a estos manuales