Crestron IM-WCVI Guía de instalación descargar pdf (Pagina 5)

Crestron IM-WCVI iMedia Wall Plate Computer Center with Video Interface

iMedia Wall Plate Computer

Center with Video Interface:

IM-WCVI

Introduction

Features and Functions

• Separate interface panel for use IM-WCVP iMedia Wall Plate Computer

Center with Video Control Panel

• Connects to IM-WCVP to create IM-WCCV-S Wall Plate Computer

Center with Video using CresCAT™-IM iMedia cable or other high

quality CAT5 cable (up to 40 feet)

• Connects PC and composite video (with audio) sources to iMedia systems

• Mounts in a standard, 2½ inch deep, double-gang electrical box

1. The IM-WCVI is part of the IM-WCCV-S. It must be used with the IM-WCVP.

2. For more information on CresCAT-IM cable, refer to “IM Wiring” on page 7.

The iMedia Transport

The iMedia transport utilizes a single CAT5e* type cable to transmit computer RGB,

video, and stereo audio signals to a single projector or plasma display. A typical

XGA signal (1024 X 768 pixels at 60Hz) can be transmitted up to 84 feet using

iMedia, while higher resolutions up to 1600 x 1200 can be handled over shorter

distances. Composite video signals can be transmitted up to 218 feet. Audio is

transmitted digitally at 20-bit, 48 kHz resolution. Control and power signals are also

contained on the same wire, eliminating the need for separate control or power

cables.

* For iMedia use CresCAT-IM cable, or quality CAT5e/CAT6 cable having a maximum delay skew

of 15ns per 100m.

2-Piece Wall Plate Multimedia Interface

The IM-WCCV-S is an iMedia (IM) transmitter featuring separate wall plates for

interface and control. The interface panel (IM-WCVI) is designed to install in a

Operations & Installation Guide – DOC. 6488 iMedia Wall Plate Interface: IM-WCVI • 1

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sin comentarios

Crestron IM-WCVI Guía de instalación Pagina 5