Crestron DTT-17 Especificaciones descargar pdf (Pagina 20)

DualTouch

Technology Touch Screen Crestron DTT-15V3

Hardware Hookup

Refer to the following illustration and complete the connections as specified. Ensure

power is removed from both the UPX-2 and the DTT-15V3 before beginning.

CAUTION: To avoid damage to the DTT-15V3 or to the video card, never connect

or disconnect the video or power cable while the DTT-15V3 or the UPX-2 are

powered.

NOTE: The USB cable may be extended using up to four 16-foot active extensions.

Each extension cable must contain a hub (repeater) to regenerate the USB signal

(maximum of 64 feet). For longer extensions, Crestron has tested and approved the

IOGEAR

USB Extender model GUCE50, which allows up to 150 feet over CAT5.

NOTE: Using high quality cable, the VGA cable may be extended up to a

maximum of about 10 meters (~33 feet) for analog VGA at 1024 x 768. If a longer

run is required, add VGA extenders or VGA distribution amplifiers.

1. Connect the RGB/VGA cable, linking the UPX-2 RGB OUTPUT A

connector to the DTT-15V3 ANALOG RGB IN connector.

2. Connect the USB cable, linking the UPX-2’s USB port to the DTT-15V3’s

USB port.

3. Connect the power supply line cord to an AC outlet and the power supply

adaptor.

4. Plug the power adaptor cord into the DTT-15V3’s DC IN (12V) port.

5. Apply power to the DTT-15V3. The power indicator should light up amber.

6. Apply power to the UPX-2. When a video signal is applied to the

DTT-15V3, the power indicator turns blue.

16 • DualTouch

Technology Touch Screen: DTT-15V3 Operations Guide – DOC. 6632C

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Crestron DTT-17 Especificaciones Pagina 20