Crestron TPMC-9L Guía de instalación descargar pdf (Pagina 17)

Crestron TPMC-9L 9” Wall Mount Touch Screen

Configuring the Touch Screen

The TPMC-9L is configured from the setup menu.

NOTE: The only connection required to configure the touch screen is power. Refer

to “Hardware Hookup” which starts on page 31 for details.

NOTE: The TPMC-9L can take up to 45 seconds to boot to a display after initial

power up.

NOTE: If no project has been loaded or if an invalid project has been loaded, the

touch screen displays an error message and defaults to the setup menu screen.

The setup screens allow basic configuration procedures prior to regular operation of

the touch screen. To enter the setup screens, touch the panel while applying power to

the unit. The setup screens can also be entered by touching the upper left corner,

lower left corner, upper right corner and lower right corner of the panel twice in

sequence (upper left, lower left, upper right, lower right, upper left, lower left, upper

right, lower right). This sequence must be performed within five seconds and touches

must be all the way in the corners.

An third way to enter the setup screens, for TPMC-9L touch screens using the button

bezel, is to press the first four buttons from the top on the left side of the screen,

twice in sequence (1, 2, 3, 4, 1, 2, 3, 4). Refer to the following illustration for push

button numbering.

Push Button Layout and Join Number Assignment

Operations & Installation Guide – DOC. 7030F 9” Wall Mount Touch Screen: TPMC-9L • 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Sin comentarios

Crestron TPMC-9L Guía de instalación Pagina 17