Crestron CNWM-LU12 Guía de instalación descargar pdf (Pagina 7)

CDI-S200 Installation Guide v1.0 7

CX263 switch settings

After the CDI-S200 card has been tted, and

J4 – J6 and J19 – J24 (on the CX263 main

PCB) set as described above, the top cover of

the CX263 can be replaced, using the original

screws.

The three blue rear panel switches DIG/

AN (adjacent to the RSL-6 connectors)

should now be set to DIG – i.e., in their ‘out’

position. The three blue rear panel switches

FR/REM (next to them) should be set to

REM – i.e. in their ‘in’ position. The CX263 is

now ready for full serial remote control.

Partial music function control

It is also possible to congure the CX263

so that the CDI-S200 only controls certain

unit functions, leaving others to be manually

controlled, either from the front panel or from

a Cloud RSL-6 remote control plate. If this is

required, set the rear panel switches and the

internal jumpers J19 to J24 according to the

table below.

MUSIC

SOURCE

MUSIC

LEVEL

DIG/AN

switch

FR/REM

switch

Jumpers

J19, J21, J23

Jumpers

J20, J22, J24

CDI-S200 CDI-S200 DIG REM * SW

CDI-S200 RSL-6/RL-1 AN REM DG SW

Front panel CDI-S200 DIG REM * FR

* When the CDI-S200 is to control music level, jumpers J19, J21 and J23 may be set in either the DG or SW position.

However, they must NOT be removed altogether.

1 2 3 4 5 6 7 8 9 10 11 12 13

Sin comentarios

Crestron CNWM-LU12 Guía de instalación Pagina 7