Crestron TPS-CBL-T Especificaciones descargar pdf (Pagina 44)

Isys

Wall Mount Touchpanels Crestron TPS-12L/15L/17L

Exploded view of Mounting the TPS-12L in the Optional BB-12L Back Box

Touchpanel Removal

If it is necessary to remove the touchpanel after it has been installed into a mounting

surface, complete the following steps in the order provided to remove the

touchpanel. The only tool required is a #2 Phillips tip screwdriver.

1. Lift the bezel off the touchpanel. Do not apply excessive pressure to the

touchscreen.

2. Loosen and remove the screws that secure touchpanel to the mounting

option in use.

3. Using equal pressure, carefully remove the touchpanel from the opening.

4. If necessary, secure and label the attached cables before disconnecting them

from the back of the touchpanel.

Hardware Hookup

Ventilation

The TPS-12L/15L/17L should be used in a well-ventilated area. The venting holes

should not be obstructed under any circumstances. If the TPS-12L/15L/17L is hot to

the touch, consider using forced air ventilation.

To prevent overheating, do not operate this product in an area that exceeds the

environmental temperature range listed in the table of specifications. Consideration

must be given if installed in a closed or multi-unit rack assembly since the operating

ambient temperature of the rack environment may be greater than the room ambient

temperature. Contact with thermal insulating materials should be avoided on all sides

of the unit.

40 • Isys

Wall Mount Touchpanels: TPS-12L/15L/17L Operations Guide – DOC. 6355A

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 65 66

Sin comentarios

Crestron TPS-CBL-T Especificaciones Pagina 44