Crestron Adagio ATC-AMFMSR Guía de instalación descargar pdf (Pagina 10)

AM/FM/XM Tuner Card Crestron Adagio

ATC-AMFMXMD

Setup

This section contains hardware installation and setup instructions for the

ATC-AMFMXMD.

Required Tools/Hardware

1. Small flat bladed screwdriver

2. Grounding strap (encouraged)

Installation

CAUTION: The ATC-AMFMXMD and Adagio

systems contain electrostatic

discharge (ESD) sensitive devices. Crestron encourages you to wear a grounding

strap to avoid damaging the card and/or the host system.

When inserting a card into an Adagio system that features tuner card slots you may

need to move other source connections if designated connectors are occupied by

other sources. For programming purposes, slots and source connections are matched

according to the following table:

Slot 1 Slot 2 Slot 3

Source

Connections

1&2 3&4 Refer to

note below.

CAUTION: Do not connect external sources to SOURCES connectors used by

tuner cards.

CAUTION: Be certain to insert tuner card before applying power to the Adagio

system.

NOTE: If the user intends to use the out-of-the-box functionality, do not to use

SLOT 3 for tuner cards; otherwise, SLOT 3 uses source connections 5 and 6. Does

not pertain to the CEN-TRACK.

Begin the card insertion procedure with these steps:

1. Disconnect power from the Adagio system.

2. Remove the slotted screws securing any cover plate that may be

fastened to the slot you intend to use then set the screws and the cover

plate aside.

3. Unpack the ATC-AMFMXMD card.

4. As shown in the photo on the next page, position the

ATC-AMFMXMD card so the print on the faceplate is right side up

and the side rails of the card slide into the plastic slots mounted on left

and right inside walls of the Adagio system.

6 • AM/FM/XM Tuner Card: ATC-AMFMXMD Operations & Installation Guide – DOC. 6605A

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

Crestron Adagio ATC-AMFMSR Guía de instalación Pagina 10