Crestron MT-1000C Guía de usuario descargar pdf (Pagina 27)

Crestron MT-1000C 3.8 Inch RF Remote

Project Upload and Firmware Upgrade

Before loading a compiled VT Pro-e project or upgrading the device firmware,

the USB cable supplied with the MT-1000C must be connected to the USB

interface port on the rear of the MT-1000C and the USB port of the PC as shown

in the following diagram.

NOTE: You cannot operate the MT-1000C while a file is loading.

NOTE: All of the communication parameters are automatically set when

uploading to the MT-1000C.

NOTE: An error message will appear on the PC if you have installed the USB

connector up side down.

Typical Connection Diagram when Uploading and Upgrading

NOTE: The Crestron Toolbox (replacement for Crestron Viewport) is a broad-

based software package that accomplishes multiple system tasks, primarily using

an RS-232 or TCP/IP connection between a PC and one or more Crestron

control systems. You can use the Crestron Toolbox to:

● Observe system processes

● Upload operating systems and firmware

● Upload programs and touchpanel projects

● Set or change device Network IDs

● Change serial numbers

● Run scripts to automate tasks

● Perform system diagnostics, and much more

The Crestron Toolbox allows you to perform these functions using simple

graphical views and click and drag methods.

Programming Guide – DOC. 6330A 3.8 Inch RF Remote: MT-1000C • 23

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Sin comentarios

Crestron MT-1000C Guía de usuario Pagina 27