Crestron TPS-MEM64MB Guía de instalación descargar pdf (Pagina 10)

Flash Memory Crestron TPS-MEM64MB & TPS-MEM128MB

NOTE: The diagrams in this procedure show a TPS-5000 touchpanel,

but the steps for all other TPS touchpanels are identical.

1. If an optional external power pack is utilized, disconnect the

power pack from the touchpanel rear port labeled 24VDC 2A.

2. To prevent errors when re-connecting, label and disconnect all

cables attached to the touchpanel’s rear panel ports.

3. If necessary, use the touchpanel position lock buttons to adjust

the touchscreen to the maximum (most vertical/upright) angle.

4. To prevent scratching of the screen, place the touchpanel

facedown onto a padded surface.

5. With one hand, hold the touchpanel base cover in place.

6. As shown in the following diagram, use a #1 Phillips

screwdriver to loosen and remove the eight screws that secure

the touchpanel base cover.

Remove Touchpanel Base Cover Screws

7. Place the touchpanel upright on the work surface.

8. As shown in the following diagram, remove the touchpanel

base cover by raising it upwards and rearward.

6 • Flash Memory for TPS User Interfaces: TPS-MEM64MB & TPS-MEM128MB Installation Guide - DOC. 6261

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sin comentarios

Crestron TPS-MEM64MB Guía de instalación Pagina 10