Crestron TPMC-10 Especificaciones descargar pdf (Pagina 22)

Isys i/O

™

WiFi Touchpanel Crestron TPMC-10

To set up a WAP on the B-side of the C2ENET-2 dual-port Ethernet card, do the

following:

1. Configure an IP address on port B (refer to the latest version of the Crestron

C2ENET-1/-2 Operations and Installation Guide (Doc. 5962).

2. Configure the WAP to be on the same subnet as port B; use port B’s address

as the default gateway.

3. Configure the TPMC-10 to connect to the WAP (refer to “

WiFi SETUP” on

page

13).

4. Configure the IP table in the TPMC-10 to point to the port B address.

General Use and Safety

WARNING: To avoid shock hazard and possible damage to the unit, do not use the

touchpanel in the rain or expose it to unnecessary moisture.

Recommended Touchpanel Cleaning

Keep the surface of the touchscreen free of dirt, dust, or other materials that could

degrade optical properties. Long-term contact with abrasive materials can scratch the

surface, which may detrimentally affect image quality.

For best cleaning results, use a clean, damp, non-abrasive cloth with any

commercially available non-ammonia glass cleaner. The surrounding plastic

enclosure may not provide a watertight seal. Therefore, apply cleaning solution to

the cloth rather than the surface of the touchscreen. Wipe the touchscreen clean and

avoid leakage of moisture beneath the panel.

18 • Isys i/O

™

WiFi Touchpanel: TPMC-10 Operations Guide - DOC. 6284C

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

Sin comentarios

Crestron TPMC-10 Especificaciones Pagina 22