Crestron Adagio ATC-AMFMSR Especificaciones Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 5
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
Adagio
AMS
Media System
quickstart guide
www.crestron.com
800.237.2041
Specifications subject to
change without notice
201.767.3400
For details, refer to the
AMS Operations Guide, Doc. 6509.
QUICKSTART DOC. 6510C (2015964) 07.13
2
4
Connect Keypads, Controllers, and Speakers
A. Connect the previously installed 16 AWG minimum (up to 12
AWG) speaker wire to the speakers in rooms 1 - 6. Observe the
polarity of the wires to each speaker (black = –, red = +).
NOTE: Use speakers that are rated for full available output. Do not
connect more than two 8-Ohm speakers in parallel or one 4-Ohm
speaker to each output.
B. Connect the speaker wire from rooms 1 - 4 to the AMS
ROOMS connectors using the 2-pin socket connectors provided.
C. Connect the speaker wire from rooms 5 or 6 to the AMS
BACK connectors using the 2-pin socket connectors provided.*
D. Connect the keypads (C2N-DBF12) and/or controllers (APAD)
in rooms 1 - 6 to previously installed Cresnet cables.
E. Connect the Cresnet cables from the rooms to the appropriate
NET connectors on the AMS (e.g., Room 1 to Net 1, etc.). Typical
wiring connections are shown below.
*Connection to rooms 5 and 6 depend on the configuration selected. For detailed
information, refer to the AMS Operations Guide.
3
Connect Optional Network and Audio Sources
A. Connect the optional Adagio Audio Server (AAS) and
CEN-IDOC to the AMS through a third party DHCP-enabled
Ethernet router using CAT5/5E cables (not supplied).
B. Connect the docking station (CEN-IDOC-DS) supplied with
the optional CEN-IDOC to the port on the rear of the CEN-IDOC
using the supplied cable.
C. Connect the audio outputs of the CEN-IDOC and AAS to
available AMS SOURCES connectors using RCA cables:
Connect the CEN-IDOC outputs to source 5.
Connect the AAS outputs to sources 7 - 10.
NOTE: If the configuration includes an AAE, connect CEN-IDOC
and AAS audio outputs to the AAE loop through SOURCES
connectors, not to the AMS. Refer to Step 5.
DHCP-Enabled
Ethernet Router
CEN-IDOC
AMS
AAS
CEN-IDOC-DS
AMS
AAS
CEN-IDOC
Red
White
Blue
Black
Left
Right
+
+
OR
APAD
Controller
C2N-DBF12
Keypad
N
-DBF12
eypad
O
R
A
PA
Controller
C
2
N
Ke
Rooms
5 - 6*
Right
+
OR
Cresnet
AMS
From Rooms 1- 4
From Rooms 1- 6
Speaker Wire
Left
Right
+
+
OR
APAD
Controller
C2N-DBF12
Keypad
N
-DBF12
eypad
OR
AP
A
D
Controller
C
2
N
Ke
Rooms
1 - 4
From Rooms 5 - 6
Adagio
®
AMS
Vista de pagina 1
1 2 3 4 5

Comentarios a estos manuales

Sin comentarios