Crestron TPMC-3X Series Manual de usuario descargar pdf (Pagina 6)

Battery Pack Crestron TPMC-3X-BTP

Setup

Removal

NOTE: To prevent damage to multi-pin connector and wiring, use care

when handling the TPMC-3X-BTP.

Perform the following procedure to remove the existing TPMC-3X-BTP

from a TPMC-3X, TPMC-3X-LP or MTX-3 touch screen:

1. Place the touch screen with the screen side down on a clean, soft

surface.

2. Remove the battery compartment cover on the rear of the touch

screen.

3. Lift the TPMC-3X-BTP out of the battery compartment, to gain

easier access to the multi-pin connector.

4. Using the flat end of a small slot head screwdriver, gently pry the

multi-pin connector off the corresponding connector in the battery

compartment of the touch screen.

Installation

After completing removal of the old TPMC-3X-BTP from the touch

screen (refer to “Removal” above), perform the following procedure to

install the TPMC-3X-BTP in a TPMC-3X, TPMC-3X-LP or MTX-3

touch screen:

1. Carefully connect the multi-pin connector of the TPMC-3X-BTP

with the corresponding connector inside the battery compartment.

The pin side of the connector should be facing upward (toward the

rear of the touch screen). Red wires should be above black wires

(toward the top of the touch screen). Ensure the connector is fully

seated.

2. Place the TPMC-3X-BTP in the battery compartment, oriented so

the wires for the multi-pin connector are on the bottom. Refer to

the photo on the following page.

3. Re-attach the battery compartment cover.

4 • Battery Pack: TPMC-3X-BTP Installation Guide – DOC. 6796D

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Crestron TPMC-3X Series Manual de usuario Pagina 6