Crestron TPS-RFGWX Especificaciones descargar pdf (Pagina 13)

Crestron TPS-RFGWX Two-Way RF Transceiver

Operations Guide - DOC. 5847A Two-Way RF Transceiver: TPS-RFGWX • 9

NET ID assignment must match the assignment made in the SIMPL Windows

project. In addition, a Low Power Mode setting lets you reduce the transmission

power to reduce or eliminate interference with other RF devices communicating with

or near the Cresnet system.

NET ID

For a definition of Viewport,

refer to the Note on page 12

Every piece of equipment and user interface within the Cresnet system requires a

unique NET ID. These codes are two-digit hexadecimal numbers from 03 to FE. The

NET ID of the unit must match the NET ID specified in the SIMPL Windows

program. The NET ID of the TPS-RFGWX is factory set to 52. The NET IDs of

multiple TPS-RFGWXs must all be unique and changed from a PC via the Crestron

Viewport. To set or change the NET ID of the TPS-RFGWX, complete the

following steps.

1. Attach only one TPS-RFGWX to the control system (verify that the

software is running).

2. Open the Crestron Viewport (Version 3.53).

Either launch the stand-alone version of Viewport, or start SIMPL

Windows or VT Pro-e, and from the menu bar, select Tools |

Viewport.

3. From the Viewport menu, select Functions | Set Network ID. The

software checks the baud rate and then opens the “Set Network ID”

window.

4. In the “Set Network ID” window, select the TPS-RFGWX from the

Current Network Devices text window.

5. From the Choose the new network ID for the selected device (Hex):

text box, select the new Net ID for the TPS-RFGWX.

6. Click Set ID to initiate the change. This will display the “ID

command has been sent” window.

7. In the “Command Complete” window, click OK.

8. In the Current Network Devices text window, verify the new NET ID

code.

9. In the “Set Network ID” window, click Close.

NOTE: The new NET ID code may also be verified by selecting Diagnostic |

Report Network Devices in the Viewport.

10. Attach each TPS-RFGWX to be added to the Cresnet system

individually and repeat this procedure as needed.

Channel ID, Band, and Power Setting

Each gateway communicating with a touchpanel must have a channel ID and band

assignment that matches the RF channel and band assignment of the touchpanel.

There are 16 possible channels ranging from 0 to F (hexadecimal number) and the

channel assigned to each touchpanel must be unique. Similarly, there are 10 possible

bands that can be selected, and the selection made for the touchpanel and the

gateway must match. Also, if two or more gateways are operating in close proximity

and experiencing interference problems, you can select the Low Power Mode to

reduce signal strength, which may eliminate the interference.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comentarios a estos manuales

Sin comentarios

Crestron TPS-RFGWX Especificaciones Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Crestron TPS-RFGWX