Crestron TPS-RFGWX Especificaciones descargar pdf (Pagina 14)

Two-Way RF Transceiver Crestron TPS-RFGWX

10 • Two-Way RF Transceiver: TPS-RFGWX Operations Guide - DOC. 5847A

These settings are made from a PC via the Crestron Viewport. Complete the

following steps:

1. Open the Crestron Viewport. (Version 3.53).

Either launch the stand-alone version of Viewport, or start SIMPL

Windows and from the menu bar, select Tools | Viewport.

2. From the Viewport menu, select Functions | Set RFGWX Channel.

The software checks the baud rate and then opens the “RFGWX

Channel ID” window as shown below.

“RFGWX Channel ID” Window

3. In the top portion of the “RFGWX Channel ID” window, select the

network ID of the gateway that requires the RF channel to be set.

4. In the middle portion of the window, select the desired channel ID

for each gateway (up to 16) and all touchpanels (up to 15) associated

with that gateway.

In the bottom portion of the window, select the desired band for the

gateway. The choices correspond with the band names shown in the

table on the next page. The table shows the 802.11b channels within

each band that are occupied by the STX-1700CXP. Selection of a

band is based on a number of factors, including the need to avoid

interference with nearby RF devices, and compliance with local

communication laws. In the US, Crestron recommends using Bands 5

(USA comp 1) through 9 (USA comp 5). Bands 1 through 4 (France,

Spain, Japan, and Canada) are intended for use in Cresnet systems

outside the US. The default setting is Band 0, USA (original), which

is not Wi-Fi friendly. Note that at this setting, the gateway can

communicate with the touchpanels whether they are Wi-Fi friendly

or not, since Band 0 is the default setting for both versions.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Sin comentarios

Crestron TPS-RFGWX Especificaciones Pagina 14