Crestron C2N-ANLZ Especificaciones descargar pdf (Pagina 14)

Cresnet

Analyzer Crestron C2N-ANLZ

Operation

The C2N-ANLZ can be operated from the buttons on the device or via console

commands from a connected PC.

Button Operation

Using the buttons on the C2N-ANLZ, you can:

• Format a memory card

• Log Cresnet data to a memory card

• Mark events in the log

Operational Status

The PWR LED indicates the operational status of the C2N-ANLZ:

• Off: The C2N-ANLZ is sleeping

• Blink: Operating from 9 Volt battery. The C2N-ANLZ will switch to a low-

power operating mode.

• On: Operating from Cresnet power.

Format a Memory Card

Formatting a memory card will erase any files that are stored on the card. To format

a memory card:

• Install the memory card as described on page 8.

• Press and hold the INIT button for five seconds. The INIT LED will turn

on. If text console communications are established with the C2N-ANLZ,

messages indicating the status of the format process will be displayed.

• When the LED turns off, the card is formatted.

Log Data to a Memory Card

Logged data is written to a text file on the memory card. To log Cresnet data to a

memory card:

• Install the memory card as described on page 8.

• To start logging data, press and release the LOG button. A new log file is

created and the LOG LED will light and then start blinking. If text console

communications are established with the C2N-ANLZ, a message will be

displayed indicating the start time of the log.

• To stop logging data, press the LOG button. The LOG LED will light and

then turn off. If text console communications are established with the

C2N-ANLZ, a message will be displayed indicating the end time of the log

in addition to file size information.

10 • Cresnet

Analyzer: C2N-ANLZ Operations Guide – DOC. 6473

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Crestron C2N-ANLZ Especificaciones Pagina 14