Crestron ST-VS Especificaciones descargar pdf (Pagina 14)

Video Sensor Module Crestron ST-VS

Setting the Net ID in Device Settings

Double-click the ST-VS icon to open the “Device Settings” window. This window

displays the ST-VS device information. If necessary, select the Net ID tab to change

the Net ID as shown in the following figure.

ST-VS “Device Settings” Window

NOTE: SIMPL Windows automatically changes the Net ID values of a device

added to a program if a duplicate device or a device with the same default Net ID

already exists in the program. Always ensure that the hardware and software settings

of the Net ID match. For Net ID hardware setting details, refer to “Identity Code” on

page 6.

ST-VS Symbol in Programming Manager

Programming Manager is where programmers “program” a Crestron control system

by assigning signals to symbols. The following graphic shows the ST-VS symbol in

the SIMPL Windows’ Programming Manager.

Detail View of the ST-VS in SIMPL Windows Programming Manager

The ST-VS provides four discrete video sensors. The <sense> outputs go high

whenever the presence of a video signal is detected at the corresponding input.

10 • Video Sensor Module: ST-VS Operations Guide – DOC. 5767A

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Sin comentarios

Crestron ST-VS Especificaciones Pagina 14