Crestron iMedia IM-RXV1 Guía de instalación descargar pdf (Pagina 18)

iMedia Receiver/Processor with Video Crestron IM-RXV1 & IM-RXV3

Connect the Device

Make the necessary connections as called out in the illustrations that follows this

paragraph. Apply power after all connections have been made.

When making connections to the IM-RXV1 and IM-RXV3, consider the following:

• Use Crestron power supplies for Crestron equipment.

• The included cable cannot be extended.

Hardware Connections (Front, IM-RXV3 shown)

IM INPUT:

iMEDIA PORT RECEIVES

AUDIO, VIDEO, AND RGB

SIGNALS

AUDIO:

BALANCED OR

UNBALANCED OUTPUT

TO AMPLIFIER

SPEAKER:

AMPLIFIED STEREO

AUDIO OUTPUT

NOTE: For optimum performance, Crestron strongly recommends using

CresCAT-IM cable, available from Crestron. Other high-quality/low skew

CAT5e/CAT6 wiring may also be used with varying performance.

Hardware Connections (Rear)

POWER:

FROM POWER

SUPPLY

(18 VDC, 3.0 A)

RELAY OUTPUT:

TWO LOW VOLTAGE

CONTACT CLOSURE

RELAYS

IR OUTPUT:

TO STIRP

LAN:

10/100 BASE-T

ETHERNET TO

LAN

COMPOSITE VIDEO OUTPUT:

TO DISPLAY DEVICE

DIGITAL INPUTS:

FOUR SCHMIDT

TRIGGER TYPE

COMPUTER:

RJ-11 SERIAL PORT

TO LOAD FILES OR

CONSOLE

COM:

BI-DIRECTIONAL RS-232 WITH

HARDWARE AND SOFTWARE

HANDSHAKING AND MODEM CONTROL

RGB OUTPUT:

TO DISPLAY DEVICE

NOTE: the power supply cable is equipped with a snap lock connector. Always

disconnect the power cable by pulling back on the snap lock of the connector. Never

pull the power cable by the cord.

14 • iMedia Receiver/Processor with Video: IM-RXV1 & IM-RXV3 Operations & Installation Guide – DOC. 6478

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Comentarios a estos manuales

Sin comentarios

Crestron iMedia IM-RXV1 Guía de instalación Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Crestron iMedia IM-RXV1