Crestron PAC2M Especificaciones descargar pdf (Pagina 15)

Crestron PAC2M Professional Automation Mini Computer

5940) and CAENIB – Automation Enclosures Installation Guide (Doc. 6562) for

more information on the CAEN and CAENIB. The following procedure assumes

installation in a double-wide CAEN. Complete the procedure below to attach the

PAC2M to the CAEN. A #2 Phillips screwdriver is required.

1. Using a #2 Phillips screwdriver attach the four supplied self-tapping

pan Phillips screws (8B x ¼” length) by screwing them in partially, to

allow room to mount the PAC2M (refer to illustration that follows).

2. Mount the PAC2M on the CAEN (where you attached the screws),

slide the unit to the right to ensure the screws fully engage the slots in

the flanges and tighten the screws.

NOTE: For a single-wide CAEN, attach screws on right (screw them in partially),

mount the PAC2M where you attached screws, attach screws on left and fully tighten

all screws.

Mounting the PAC2M in the CAEN

Double-wide

CAEN

CLX-Series Module

8B ¼" screw

PAC2M

Power Supply

The PAC2M can be powered through the 2-pin PWR connector or by an external

power pack (such as the PW-2420RU) but not by both. Using the

PW-2420RU, the PAC2M may provide power to peripheral Cresnet devices (via the

Operations Guide – DOC. 6507A Professional Automation Mini Computer: PAC2M • 11

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Sin comentarios

Crestron PAC2M Especificaciones Pagina 15