Crestron ATC-AUDIONET Guía de instalación descargar pdf (Pagina 12)

Internet Radio Tuner Card Crestron ATC-AUDIONET

Hardware Hookup

Connect the Device

Make the necessary connections as called out in the illustration that follows this

paragraph. Apply power after the LAN connection has been made.

Hardware Connections for the ATC-AUDIONET

LAN:

10/100BASE-T

Ethernet to LAN

NOTE: To prevent overheating, do not operate this product in an area that exceeds

the environmental temperature range listed in the table of specifications.

Memory Card

The ATC-AUDIONET includes a 512 MB Multimedia Memory Card which can be

used to store and play supported files.

CAUTION: The ATC-AUDIONET and host system contain electrostatic discharge

(ESD) sensitive devices. Crestron encourages you to wear a grounding strap to avoid

damaging the card and/or the host system.

To install or remove the memory card:

1. Disconnect power from the host device.

2. If the ATC-AUDIONET is already installed in an AES, AMS, AMS-AIP,

or CEN-TRACK, it must be removed.

a. Using a flat blade screwdriver, loosen the two slotted screws.

b. Gently pull the ATC-AUDIONET from the host device by the loosened

screws.

3. Install or remove the memory card.

To install the memory card:

a. As shown in the following diagram, insert the memory card into

the card slot, contacts facing down.

Insert Memory Card

Memory Card

Insert

8 • Internet Radio Tuner Card: ATC-AUDIONET Operations & Installation Guide – DOC. 6933A

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Sin comentarios

Crestron ATC-AUDIONET Guía de instalación Pagina 12