Crestron TPS-MEM16MB Guía de instalación Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
Flash Memory Crestron TPS-MEM16MB & TPS-MEM32MB
2 Flash Memory for TPS User Interfaces: TPS-MEM16MB & TPS-MEM32MB Installation Guide - DOC. 5927
As of the date of manufacture, this unit has been tested and found to
comply with specifications for CE marking.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Memory Module Verification
It is possible to verify the total amount of flash memory residing on a
given user interface if the amount is unknown. This action can be taken
locally (user interface within close physical proximity, and not
necessarily networked) or remotely (networked user interface located
over some distance).
Local Verification
Simply enter 'SETUP MODE' as described in the "Configure the …"
section of each user interface Operations Guide. From the Main Menu,
navigate to the Diagnostics Menu and select the Display Configuration
button. The new screen displays a list of configuration information.
Search for the item titled 'Flash Total Size'. The amount of flash memory
residing in the user interface is shown.
Remote Verification
A PC running SIMPL™ Windows
or VisionTools™ Pro-e and
connected to the Crestron control system (with the user interface
connected via Cresnet) is required for remote verification. From the
Viewport enter Remote | Remote Console | Connect to open the "Select
Network ID" window. Enter or scroll down to the ID of the user
interface. Click on the OK button and observe the "TPS>" prompt in the
Viewport. Enter a question mark (?) and carriage return. The Viewport
replies with a list of optional commands. The command of interest for
remote verification is "SHowhw". Enter that command and a carriage
return to display a list of configuration information. Search for the item
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comentarios a estos manuales

Sin comentarios