Crestron QM-MD8x8 Especificaciones descargar pdf (Pagina 20)

8X8 QuickMedia

Matrix Switcher Crestron QM-MD8X8

Suggested Power Connections for QM-MD8X8

QM-MD8

QUICKMEDIA RECEIVE

PROCESSO

QM-RMCRX-BA

300 WATT POWER SUPPLY

C2N-SPWS300

NOTE: The QM-MD8X8 can only be powered by the 4-position terminal block

connector labeled NET.

NOTE: Cresnet data is fed through the NET connector that is internally wired to the

4-position mini-terminal block connector at each QM connector.

NOTE: In the configuration shown, the C2N-SPWS300 can operate in the “PWR

ON” position or the “PWR OFF SLAVE” position. For more information, refer to

the latest revision of the C2N-SPWS300 System Power Supply Operations Guide

(Doc. 8190).

NOTE: Power to the QM ports on the QM-MD8X8 can be applied using other

configurations. The total power usage of each port group must not exceed the port

group’s available input power. For example, if 75 watts is supplied to QM inputs 1

through 4, the total power consumption for those ports cannot exceed 75 watts.

Label the Buttons

Use Crestron Engraver software to print custom labels for the QM-MD8X8’s front

panel buttons and LEDS. Crestron recommends printing on 100-pound paper. Paper

weighing less than 100 pounds will tend to crumple while sliding in, while paper

weighing more than 100 pounds may not fit.

Labels can also be created using a 3/8” label maker.

16 • 8X8 QuickMedia

Matrix Switcher: QM-MD8X8 Operations Guide – DOC. 6572A

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Sin comentarios

Crestron QM-MD8x8 Especificaciones Pagina 20