Crestron TPMC-10-DSW Guía de instalación descargar pdf (Pagina 11)

Crestron TPMC-10-DSW Docking Assembly for TPMC-10

4. With Cresnet power off, feed the Cresnet cable through the grommet in

the bottom of the unit, and then through the captive tie-wrap on the rear

plate of the unit.

Attach the supplied terminal block connector to the Cresnet cable and

plug into the port on the PC board. Make sure the cable is not pulling

on the PC board connector, and tighten the tie-wrap. (Refer to the

following illustration.)

Routing and Attaching the Cresnet Cable

PC Board

Tie-Wrap

Grommet

Terminal Block

Connector

5. As shown in the following illustration, position the TPMC-10-DSW

into the wall opening. Secure it to the wall using four screws A (not

supplied).

Installing the TPMC-10-DSW

Screws B

Wall

Stud

Screws A

Plate

Alignment

Screw

Latch

Adjusting

Screw

6. Position the bezel on the TPMC-10-DSW.

Operations and Installation Guide - DOC. 6400 Docking Assembly for TPMC-10: TPMC-10-DSW • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

Crestron TPMC-10-DSW Guía de instalación Pagina 11