Crestron TPMC-10-DSW Guía de instalación descargar pdf (Pagina 14)

Wall Mount Docking Station for TPMC-8X Series Crestron TPMC-8X-DSW

2. To remove the bezel from the TPMC-8X-DSW, first remove the two rubber

caps covering the screws near the top of the bezel. Then remove the screws

that secure the bezel to the TPMC-8X-DSW. Gently pry the top of the bezel

away from the TPMC-8X-DSW and finally, lift the bezel slightly to clear

the four clips on the bottom edge of the TPMC-8X-DSW. Do not apply

excessive pressure.

3. To disconnect the bezel from the TPMC-8X-DSW, slide the connector on

the upper right of the bezel from its slot, then disengage the connectors.

(Refer to the illustration at the bottom of page 8.)

4. Loosen and remove the four screws that secure TPMC-8X-DSW to the

mounting option in use.

5. Using equal pressure, carefully remove the TPMC-8X-DSW from the

opening.

6. If necessary, secure and label the attached cables before disconnecting them

from the side of the TPMC-8X-DSW.

Hardware Hookup

Make the necessary connections as called out in the illustration below. Apply power

after all connections have been made.

When making connections to the TPMC-8X-DSW, use Crestron power supplies for

Crestron equipment.

Hardware Connections for the TPMC-8X-DSW

LAN:

10BASE-T/100BASE-TX

High Speed Ethernet

USB (2):

Kyeboard, Mouse and

Storage Devices

PWR:

24 VDC Input

AUDIO:

To Balanced/Unbalanced

Stereo Line Level Inputs

NOTE: If the TPMC-8X-DSW is to be fed power from a Cresnet bus (the 24 and G

lines), be sure that the Cresnet data lines (Y and Z) are not connected to the

TPMC-8X-DSW, nor shorted together, to ground or to any metal surface. Be sure to

isolate them properly and prevent them from shorting to anything.

NOTE: The maximum continuous current from equipment under any external load

conditions shall not exceed a current limit that is suitable for the minimum wire

gauge used in interconnecting cables. The ratings on the connecting unit's supply

input should be considered to prevent overloading the wiring.

10 • Wall Mount Docking Station for TPMC-8X: TPMC-8X-DSW Operations & Installation Guide – DOC. 7080B

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Crestron TPMC-10-DSW Guía de instalación Pagina 14