Crestron NAT Guía de instalación descargar pdf (Pagina 12)

2-Series Feature Crestron NAT

7. Click OK to accept the values. The “Success” window opens.

“Success” Window

8. Click OK to enable the control system to reboot.

9. Disconnect the RS-232 cable from your PC and the control system.

Configuration

From a PC access the control system (C2ENET-2 card installed) web server via a

browser. The web server contains SETUP, PORTMAP, and PASSWORD pages,

which enable NAT. Open the browser and enter the address

http://xxx.xxx.xxx.xxx/setup/admin.ssi

where xxx.xxx.xxx.xxx is the IP address of the control system.

NOTE: This phase of NAT allows for administrative rights that can be protected by

a password. Administrative rights allow for the redirection of IP traffic as defined by

port assignments. Additional rights will be permitted in future releases.

Setup Page

The SETUP page, shown below, is the default opening page delivered by the web

server.

SETUP Page

8 • Network Address Translator: NAT Reference Guide – DOC. 6001

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Sin comentarios

Crestron NAT Guía de instalación Pagina 12