Crestron TPMC-8X-BTP Especificaciones descargar pdf (Pagina 44)

Isys i/O

8.4” WiFi Touchpanel Crestron TPMC-8X

“Wireless Network Connection” Window

Touch Refresh network list to scan for available access points.

The TPMC-8X is already configured for DHCP. To establish static processing or to

switch between DHCP and static IP, use the General tab of the “Wireless Network

Connection Properties” window (refer to illustration on page 39), select Internet

Protocol (TCP/IP) and touch Properties.

Touch Set up a wireless network for a home or small office to start the Wireless

Network Setup Wizard.

The Wireless Network Setup Wizard will create a network with the Network

Authentication value set to Open. If your Wireless Access Point is configured with a

value other than Open, you must set this value manually, using the Wireless

Networks tab of the “Wireless Network Connection Properties” window (refer to

illustration on page 39).

To manually configure your Wireless Access Point, perform the following

procedure:

1. In the Preferred Networks section of the window, select your network and

touch Properties to open the “Properties” window for your network.

40 • Isys i/O

8.4” WiFi Touchpanel: TPMC-8X Operations Guide – DOC. 6539C

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 85 86

Sin comentarios

Crestron TPMC-8X-BTP Especificaciones Pagina 44