Crestron TPMC-8X-BTP Especificaciones descargar pdf (Pagina 49)

Crestron TPMC-8X Isys i/O

8.4” WiFi Touchpanel

NOTE: When the panel is powered down, it will take less than 10 seconds to power

up and respond to a button press. There is no delay from Standby mode.

NOTE: If the external AC power pack is attached to the touchpanel and plugged

into an active AC receptacle or if the touchpanel is resting in the docking station and

plugged into an active AC receptacle, the panel does not power down when the

Power Down is achieved. Note that the purpose of this timeout is to maximize

battery life. Standby still functions.

Screen Brightness Details

The Screen Brightness can be varied from 0 to 100. To increase the brightness, touch

Up. To decrease the brightness, touch Down. Lower brightness settings extend

battery life.

WiFi Status Details

The WiFi Status section of the setup menu contains a bar graph showing the strength

of the WiFi signal as well as an indicator to show when the TPMC-8X is

communicating with a wireless access point (AP). SSID, BSSID, IP and MAC

addresses are also shown.

Docking Station Status Details

The Docking Station Status section of the setup menu has two indicators: Docked

Status shows when the touchpanel is mounted in a docking station and Link Status

shows when it is connected to Ethernet via the docking station. IP and MAC

addresses are also shown.

The Release button can be used to release the TPMC-8X from the docking station.

The Configure button will open the “Wallmount Docking Station Setup” window.

“Wallmount Docking Station Setup” Window

In Standard Mode, the panel to be removed from the docking station by anyone. In

Lock-Down Mode, only authorized users can remove the panel from the docking

station by first entering a passcode. The “Wallmount Docking Station Setup”

Operations Guide – DOC. 6539C Isys i/O

8.4” WiFi Touchpanel: TPMC-8X • 45

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 85 86

Sin comentarios

Crestron TPMC-8X-BTP Especificaciones Pagina 49