Crestron FT-PWR Guía de instalación descargar pdf (Pagina 14)

FlipTop Power Centers Crestron FT-PWR-D & FT-PWR-D-LG

Setup

Installation

NOTE: To prevent overheating, do not operate this product in an area that exceeds

the environmental temperature range listed in the specifications table. Consideration

must be given if installed inside a closed desk or in a closed podium since the

operating ambient temperature of these environments may be greater than the room

ambient temperature. Contact with thermal insulating materials should be avoided on

all sides of the unit.

Use the following steps to install the FT-PWR-D/-LG.

Tools required

• Phillips screwdriver (not included)

• Appropriate carpentry tools for cutout

Cable Management Kit

The FT-PWR-D/-LG is shipped with a separate cable management kit for organizing

cables fed into the power center.

Parts Supplied for Cable Management Kit

DESCRIPTION PART NUMBER QUANTITY

Cable Support Plate (FT-PWR-D only) 2011563 1

Cable Support Plate (FT-PWR-D-LG only) 2013435 1

Bushings, 0.55 inch (14 mm) ID,

0.80 inch (2.03 cm) OD

2010496 2

Bushings, 0.39 inch (9.9 mm) ID,

0.64 inch (1.63 cm) OD

2011070 2

Bushings, 0.31 inch (7.9 mm) ID,

0.50 inch (12.7 mm) OD

2009522 4

Screws, #04-40 x 1/4" (6.4 mm) 2007158 4

The cable support plate should be installed before mounting the FT-PWR-D/-LG to a

surface. The cables are threaded through the cable support plate.

1. Place bushings on the cables you wish to install in the power center (eight

bushings supplied). Use bushings appropriate for the diameter of each

cable.

2. Thread the cables through the cable support plate slots appropriate for the

size of the cable and the bushing you attached in the previous step.

3. Snap the bushings into the slots on the cable support plate.

4. Feed all excess cable through the opening.

5. Attach the cable support plate using the four #04-40 x 1/4" screws.

6. If desired, any installed cables can be secured to the bottom bar with tie

wraps (not supplied).

10 • FlipTop Power Centers: FT-PWR-D & FT-PWR-D-LG Operations & Installation Guide – DOC. 6640C

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comentarios a estos manuales

Sin comentarios

Crestron FT-PWR Guía de instalación Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para No Crestron FT-PWR