Crestron FT-PWR Guía de instalación descargar pdf (Pagina 17)

Crestron FT-PWR-D & FT-PWR-D-LG FlipTop Power Centers

Example of the Cutout Dimensions for the FT-PWR-D-LG (Not Actual Cutout Template)

7 1/4 in

(184 mm)

6 1/8 in

(156 mm)

MAXIMUM RADIUS

1/8 IN (4 MM)

NOTE: Be sure to feed the attached power cord and all required cables through the

mounting hole before inserting the FT-PWR-D/-LG.

Mounting Parts Supplied

DESCRIPTION PART

NUMBER

QUANTITY

Screws, #06-32 x 3/16”, Pan Head, Phillips 2007204 4

Screws, #10-32 x 2”, Pan Head, Phillips 2007293 4

Mounting Bracket 2013224 2

1. Install the four supplied #06-32 x 3/16”screws (2007204) to the front of the

unit. Do not fully tighten the screws. These will be used to secure the front

mounting bracket. The four screws for the rear mounting bracket come

pre-installed from the factory. Refer to the illustration “Mounting Bracket

Screw Locations” on the following page.

2. Position the FT-PWR-D/-LG in the mounting hole.

Operations & Installation Guide – DOC. 6640C FlipTop Power Centers: FT-PWR-D & FT-PWR-D-LG • 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Crestron FT-PWR Guía de instalación Pagina 17