Crestron TPS-3000L Especificaciones descargar pdf (Pagina 12)

6.4" Lectern/Wall Mounted Touchpanel Crestron Isys™ TPS-3000L

NOTE: All network wiring must consist of two twisted pairs. One twisted pair is

the +24V conductor and the GND conductor. The other twisted pair is the Y and Z

conductors.

NOTE: When daisy-chaining Cresnet units, strip the ends of the wires carefully to

avoid nicking the conductors. Twist together the ends of the wires that share a pin on

the network connector, and tin the twisted connection. Apply solder only to the ends

of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle.

Insert the tinned connection into the Cresnet connector and tighten the retaining

screw. Repeat the procedure for the other three conductors.

NOTE: For larger networks (i.e., greater than 28 network devices), it may become

necessary to add a Cresnet Hub/Repeater (CNXHUB) to maintain signal quality

throughout the network. Also, for networks with lengthy cable runs, it may be

necessary to add a Hub/Repeater after only 20 devices.

Identity Code

Every equipment and user interface within the network requires a unique Cresnet

identity code (NET ID). These codes are recognized by a two-digit hexadecimal

number ranging from 03 to FE. Refer to “Interface Menu” on page 13 for

instructions on setting the unit's NET ID. The NET ID of the unit must match the

NET ID specified in the SIMPL Windows program. Refer to “Setting the Net ID in

Device Settings” on page 26 for information about changing the ID in a SIMPL

Windows program.

Screen Orientation

When installing the TPS-3000L into a wall or lectern, the screen must be properly

oriented for optimum viewing. Incorrect orientation of the screen will not allow the

screen to be viewed at its brightest during operation.

Wall Mounting

The TPS-3000L ships in the default “Upright” configuration for mounting in a wall.

The “Upright” configuration provides optimum viewing when installed into a wall.

In this setting, the pushbuttons are located on the left side of the screen, and the

screen orientation is set to “Upright” (refer to the “Orientation” section of “Screen

Settings” which begins on page 15 for instructions) with the connectors located on

the bottom of the touchpanel. Refer to the following diagram.

Pushbutton Layout and Join Number Assignment Wall Mount

8 • 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L Operations Guide – DOC. 6077

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Sin comentarios

Crestron TPS-3000L Especificaciones Pagina 12