Crestron TPS-3000L Especificaciones descargar pdf (Pagina 24)

6.4" Lectern/Wall Mounted Touchpanel Crestron Isys™ TPS-3000L

NOTE: When sending balanced audio from a CNX-BIPAD8 or CNX-PVID device,

only the Positive (+) and Negative (-) wires are to be connected to the touchpanel.

Do not connect the Shield (S) wires.

AUDIO Pinouts-Unbalanced

PIN # DESIGNATION DESCRIPTION

1 S Ground

2 R+ Right Input (Positive)

3 R- Right Ground

4 L+ Left Input (Positive)

5 L- Left Input Ground

6 S Ground

NOTE: Using two jumpers, connect R Shield to R - and L Shield to L - respectively

at the TPS3000 Audio Input connector. Refer to the following diagram.

Wiring for Unbalanced Audio

Jumpers

NTSC/PAL INPUT

This port provides unbalanced composite and S-video input (using BNC connectors)

or balanced video input (using 6-position mini-phoenix) for video signals. Both sets

of inputs support both NTSC and PAL formats. Balanced video format is typically

used when distributing video via CAT 5 (i.e., from a Crestron CNX-PVID8x3 or

8x4). Unbalanced video is typically used when distributing video via coaxial cable.

NOTE: Cable runs for balanced video should not exceed 500 feet (152.4 meters)

and cable runs for unbalanced video should not exceed 100 feet (30.5 meters). For

distances greater than these specified lengths use a distribution amplifier.

NTSC/PAL Balanced Video Input Pinouts

PIN # DESIGNATION DESCRIPTION

1 Y(+) Luminance (Positive)

2 Y(-) Luminance (Negative)

3 Y(S) Luminance (Shield)

(continued on next page)

20 • 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L Operations Guide – DOC. 6077

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Sin comentarios

Crestron TPS-3000L Especificaciones Pagina 24