Crestron TPMC-10-DSW Manual de usuario descargar pdf (Pagina 12)

Mud Mount Kits Crestron MMK-8X-DSW & WMKM-8X-DSW

Bend Flanges

10. Use four standard drywall screws (of adequate length) to secure the mud

ring plate to the adjustment/mounting plate assembly. The screws pass

through the clearance holes in the mud ring plate and are secured in the

extruded holes of the adjustment plates.

11. Verify that the plate is level before tightening.

NOTE: Do not over tighten screws. Doing so may damage the plate.

12. Use a #2 Phillips screwdriver and tighten the drywall screws by hand so that

they slightly dimple into the holes in the mud ring plate.

13. Run the necessary cables for the TPMC-8X-DSW and secure them behind

the drywall.

14. Apply drywall joint compound as needed to finish the cutout. Avoid

covering the four tapped mounting holes.

15. When the joint compound is dry, the TPMC-8X-DSW can be installed

using the four tapped holes in the mounting plate. Refer to the latest

revision of the TPMC-8X-DSW Operations and Installation Guide (Doc.

6588) for details. Refer also to the comprehensive illustration on the

following page.

10 • Mud Mount Kits: MMK-8X-DSW & WMKM-8X-DSW Installation Guide – DOC. 6581B

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Crestron TPMC-10-DSW Manual de usuario Pagina 12