Crestron TPMC-10-DSW Manual de usuario descargar pdf (Pagina 8)

Mud Mount Kits Crestron MMK-8X-DSW & WMKM-8X-DSW

Insert and Secure Mud Ring Plate into PMK-8X-DSW (or BB-8X-DSW)

PMK-8X-DSW

DRYWALL

HOLES FOR DRYWALL SCREWS

(NOT INCLUDED)

SCREW LENGTH SHOULD NOT

EXCEED DRYWALL THICKNESS

BY MORE THAN 1/2” (12.7 MM)

MUD RING PLATE

(2017641)

5. When the mud ring plate is in position, bend the top two flanges of the plate

upward and the bottom two flanges downward.

• If mounting into the PMK-8X-DSW, bend the flanges approximately

90 degrees.

• If mounting into the BB-8X-DSW, bend the flanges back as far as they

can go.

6. Use four standard drywall screws (length should not exceed drywall

thickness by more than ½ inch) to secure the mud ring plate to the rest of

the assembly. The screws pass through the clearance holes in the

PMK-8X-DSW (or BB-8X-DSW) and are secured in the extruded holes of

the adjustment plates.

7. Verify that the mud ring plate is level.

NOTE: Do not overtighten screws. Doing so may over-dimple or rip the mud ring

plate.

8. Use a #2 Phillips screwdriver and tighten the drywall screws by hand so that

they slightly dimple into the holes in the mud ring plate.

9. Apply drywall joint compound as needed to finish the cutout. Avoid

covering the four tapped mounting holes.

10. Run the necessary cables for the TPMC-8X-DSW and secure them behind

the drywall.

11. When dry, the TPMC-8X-DSW and touchpanel can be installed using the

four tapped holes in the PMK-8X-DSW. Refer to the latest revision of the

TPMC-8X-DSW Operations and Installation Guide (Doc. 6588) for

installation instructions. Refer also to the comprehensive illustration on the

following page.

6 • Mud Mount Kits: MMK-8X-DSW & WMKM-8X-DSW Installation Guide – DOC. 6581B

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Crestron TPMC-10-DSW Manual de usuario Pagina 8