Crestron C2N-DAP8 Especificaciones descargar pdf (Pagina 17)

Crestron C2N-DAP8 Digital Audio Processor

Operations Guide – DOC. 8186 Digital Audio Processor: C2N-DAP8 • 13

Rack Mounting

WARNING: To prevent bodily injury when mounting or servicing this unit in a

rack, you must take special precautions to ensure that the system remains stable. The

following guidelines are provided to ensure your safety.

 If the rack is provided with stabilizing devices, install the stabilizers before

mounting or servicing the unit in the rack.

 When mounting this unit assembly in a partially filled rack, load the rack from

the bottom to the top with the heaviest component at the bottom of the rack.

NOTE: If rack mounting is not required, rubber feet are provided for tabletop

mounting or stacking. Apply the feet near the corner edges on the underside of the

unit.

NOTE: Reliable grounding of rack-mounted equipment should be maintained.

Particular attention should be given to supply connections other than direct

connections to the branch circuit. (e.g., use of power strips).

Two “ears” are provided with the unit and must be installed so that it can be rack

mounted. Refer to the illustration below and complete the procedures to attach ears

to the unit. The only tool required is a Phillips screwdriver.

Ear Attachment for Rack Mounting

1. Using a Phillips screwdriver, remove and retain the three side screws

closest to the front panel.

2. Position a rack ear so that its mounting holes align with the vacated

holes, and secure the ear to the unit with the three screws from step 1.

3. Repeat the procedure to attach the remaining ear to the opposite side.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 71 72

Sin comentarios

Crestron C2N-DAP8 Especificaciones Pagina 17